intermediate
General
PERRIN Cold Air Intake (PSP-INT-335)
30 minutes
6 tools
7 steps
Installation Steps
1
Detach front bumper
Detach the front bumper clips and remove it carefully to access the intake area.
2
Disconnect MAF
Disconnect the MAF sensor plug and unbolt the factory airbox
3
Remove Snorkel
Unfasten and take out the intake snorkel and any ducting pieces.
4
PERRIN brackets
Install the PERRIN mounting brackets and transfer the MAF sensor to the new intake tube.
5
Connect Intake
Connect the PERRIN intake system, secure with clamps, and tighten all fittings.
6
Reinstall bumper
Reinstall the bumper and reconnect the sensor.
7
Check fitment
Check for proper fitment and verify there are no air leaks.
Rate This Guide
0.0 (0 ratings)
Sign in to rate this guide
Comments
Comments (0)
Sign in to leave a comment
Loading comments...
Tools Required
- Ratchet and socket set (8mm & 10mm & 12mm)
- Flat and Phillips screwdrivers
- Panel clip remover
- Torque wrench (7–9 ft-lb range)
- Pliers
- Clean rags
Need Installation Help?
Loading nearby installers...